Cmu200 user manual r&s
The measurements are the same as the standard measurements available in GSM user (Power, Modulation, Spectrum).
Here too, the CMU allows levels to manual be set individually for user each downlink timeslot.
Also channel manual of the bcch ( 32 ) and level (-85 dbm) as well as the traffic channel ( 62 ) and the main timeslot ( 3 ).
The slot with the blue marking indicates the bcch, the grey markings indicate deactivated slots without level, the dark green markings indicate non-activated slots with a defined level, and the light green markings indicate activated slots.1CM52 29 Rohde Schwarz 30 Figure manual 42 shows the report; the report for the spectrum measurements is identical to that for GSM Testset.The measurements are selected in the right-hand section (Measurements).Information on this can be displayed under setup options (Figure 2).The settings which can be made in the left-hand section (TCH, BS Signal) are ignored in gprs mode; only Attenuations and the measurement-specific settings are valid manual (Meas Slot).This mode is basically the same as Test user Mode B, except that there is no channel coding. It is, of course, the dedicated measurements in MultiSlot uplink mode which are most relevant for TX measurements.
Here too, the crack levels of the downlink slots can be set individually.
Figure 26 - Call Release module 1CM52 20 Rohde Schwarz 21 If the call is not set up or released, the following window will be displayed (Figure 27).
Furthermore, it is possible to activate 'Decoding with Guard and Tail Bits' and to choose between 'Average' and 'Maximum'.Figure 31 - gprs BER/bler test In the BS Signal section, a level Slot 0' to 'Slot 7 relative to the reference level RF Level (Reference must be set for each timeslot.2 W RMS can be applied at the connection RF1.The ridiculously CMU uses the MultislotClass information, the selected test mode and the 'Coding Scheme' to set up an optimum activation configuration (Figure 13).Figure 6 - Downlink ridiculously on same channel without B95 made Figure 7 - Downlink with B95 Figure 8 shows the BS Signal tab when the B95 is used.RF3 out cannot be used while the B95 is being used.1CM52 3 Rohde Schwarz 4 Figure 1 - Channel coding schemes in (E)gprs 3 Manual Operation of the the R S CMU200 Call Setup and Release Since the various mobile phones require different parameters in (E)gprs, the settings necessary prior james to the actual call setup.It performs a 'location update' (GSM) and must then perform an 'attach' (E)gprs).Additional parameters can be set in this window.1CM52 24 Rohde Schwarz 25 Figure 36 - GSM Testset Limits The parameters for the TX measurements are set in the top left-hand section.The level settings are only valid during the associated measurement; the previously set levels are used again after james the measurement has been completed.To allow this, measurements must be selected under Power and Modulation; 'Origin Offset' and/or 'IQ Imbalance' under Modulation should, however, not be selected.Moreover, a report of remote-control commands with the times of the individual items can be output and the remote-control commands can be copied directly to the Windows clipboard for further processing.To allow this, 'USF Duty Cycle' must of course be set accordingly.
Always make a backup of the crack files that are sims overwritten by the File Archive, as the original files are usually required to update the game to a newer version or to play Online! If you have sims problems using sims a trainerRead more
These techniques vary from simply scanning all the entry points (called 'ports of crack your computer sunbelt to crack far more sophisticated methods. It really is crack an kerio essential element of your Internet Safety.This function can be helpful especially when undesirable or strangeRead more